John Deere Tractors Discussion Board |
4020 hydraulic pump leak revisited
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ted K/MN on September 12, 2004 at 14:30:23 from (205.243.25.136):
A few days ago I posted about my drippy hyd. pump on the '65 4020D. I presumed it was the shaft seal, but some of you said to check at other spots before I remove the pump. Well, I steamed the pump off as best I could, ran it for a while and soon the trickle of fluid came dripping off, but not from anywhere near the shaft seal. It is coming from the top of the pump and running down around the righthand side in the area of the piston plugs. I cannot see up in there well enough to tell exactly where it is originating from. I checked the clamps on the short hose between the top of the pump and cooler, clamps were not really tight, so after tightening them it seemed to slow some, and I ground two batches of feed with it and only a couple of drops showed up. Thought I had it taken care of. Of course just sitting still on the grinder mixer required no hyd. pressure other than to steer it around a bit in the yard. Today I hauled manure with it and a pretty good sized puddle showed on the front axle casting by the time I returned to the yard. So, questions: Is it common for the piston plugs to begin to leak? Wouldn't the oil cooler hose leak even w/o pressure, even when the engine is shut down? Finally, the manual says to remove the pump out the bottom after removing the front axle. Would it be any more hassle to go out the top after removing the radiator/fuel tank? That way, I would be able to get at the connections easier, maybe be able to replace the piston plug seals w/o taking the pump out and not have to work under the thing hoping the supports are adequate. Anybody done it this way? Any advice would be greatly appreciated. Thanks, Ted
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|