|
Implement Alley Discussion Board |
Home Made Hydraulic Top Link Picture
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert in W. Mi. on July 09, 2002 at 16:48:59 from (208.224.10.223):
Here's a picture of the adapter i made from scrap steel and a weld on "ball end". It allows the use of cheap hydraulic cyclinders to be used in place of a top link. I bought the ball end at Farm & Fleet, but i've seen them at tractors dealerships too.
I'll post two more pictures below so you can see it in use. A better cyclinder could be used, but that adds to the expense, and as the $$ goes up, you might as well buy a "heavy duty" one that's factory made!
BTW, the cyclinder i use is a 3" with a 1-1/4" shaft. I consider this all to be used only for light duty use! I'm sure you can do some improvements on my design for your own use.
Robert
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
