|
Ford Tractors Discussion Board |
Re: HYDRAULIC TUTORIAL
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brendan Casey on August 10, 2003 at 19:43:31 from (203.59.214.197):
In Reply to: HYDRAULIC TUTORIAL posted by Wayne on August 09, 2003 at 17:38:28:
Before I start, its worth reinforcing the safety concerns that have already been pointed out - always proceed with caution when suspended loads are involved. Given that troubleshooting is a logical process of elimination, my thoughts on this problem are: The fact that tilt and bucket lower work OK suggest that there is no restriction on the return side of the control valve otherwise all functions would be affected. The fact that you have swapped the hoses between the tilt section and the hoist section and the problem remains unchanged tends to suggest that the problem is not in the control valve either. Just to check this another way, I would swap the two hoses on the hoist section (so that down becomes up and up becomes down), theory being that if the problem was in this section of the valve then the bucket should go down but not up. If after doing this, the bucket will still go up but not down then it points to a problem in the hoist cylinders or somewhere between the cylinders and the control valve. If there are load control valves in the bucket hoist circuit - by this I mean counterbalance valves or velocity fuses which are installed to prevent the bucket from dropping if a hose fails, then these could be causing the problem. For a primer on hydraulic troubleshooting read the following article:
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It's Alright Where It Is! - by Anthony West. I have a tale of a different kind to tell. Whilst rooting in the hedge bottoms this week I had cause to visit Chapel lane Farm, the home of an eccentric gentleman by the name of Austin Kendall. I had heard rumours that an old Case Model C was languishing away in the back of one of the outbuildings there. So off I went in search of what would turn out to be a very rare and unusual tractor. Mr Kendall is an excitable chap to say the least. He is amongst the last of a dying breed of farmer who
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|