|
Harry Ferguson Discussion Board |
Re: carb. adjustment on a 1953 To-30
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Boogity TO-30 on September 08, 2001 at 18:31:01 from (12.64.13.126):
In Reply to: carb. adjustment on a 1953 To-30 posted by Mike Taulbee on September 08, 2001 at 13:10:41:
I recently rebuilt my Marvel-Schrader (sp??) carb. and the settings that were provided in my shop manual seemed to be great for the initial start-up. The small knob is for low speed and the intial setting is supposed to be 7/8 of a turn open. After many small adjustments I have ended up with about 7/8 of a turn open at around 450 rpm. The large knob located toward the front of the carburator top, slightly angled, is the high speed jet adjustment. This initial setting should be 1 1/4 turn open. Again after many small adjustments at about 2200 rpm under a load I ended up with 1 1/2 open for best performance. We are cautioned to never operate the engine with this setting at less than 1 1/4 open because the engine needs the cooling effect of the gas/air mixture and anything less than 1 1/4 turns open may allow some over-heating in the intake valves. I hope this helps. Please let all of us know what your final settings become. Boogity
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Ford Super Dexta - by Anthony West. The rusty blue tractor caught my eye as my truck zipped by the farm implement business. It looked so fornlorn amongst the lineup of newer equipment. But it was just the right size for my small farm. I stopped in and asked the proprietor for further information. "It's a 64 Ford Super Dexta", he said. "It's a tough little tractor, although it's a hard starter being a diesel and all." He did manage to get it running, compliments of a can of ether. Once started it putted along pretty good. It
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|