Harry Ferguson Tractors Discussion Board |
Re: Harry Ferguson 2 bit plow
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John Mason, Michigan on March 13, 2007 at 10:09:43 from (67.38.30.211):
In Reply to: Harry Ferguson 2 bit plow posted by 07Stones on March 10, 2007 at 07:09:54:
Mike, Let me know what you find (or don't) as I was in the same boat as you just over a year ago. I found a place on the east coast that can sell you the new plow share, AKA plow point, in steel or cast. They were a bit pricy though. $100.00. I ended up getting a used one for $25 at Tosch brothers in Capac/Goodels area. Got $65.00 total into the plow. I will have to look back and see where that place was. Drop me a line if need be.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|