Farmall & IHC Tractors Discussion Board |
Re: int super h
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Button on January 14, 2001 at 17:28:04 from (205.188.197.167):
In Reply to: int super h posted by jonsey on January 14, 2001 at 14:27:35:
The sup H splites between the clutch housing and the rear end housing, the screws are inside the clutch housing. but you can work on the tranny without spliting go up through the inspection plate take the u joint apart remove the clutch then you can remove the in put shaft. for your other problem check the forkes and the ball and springs that hold the forks in place. and the pilot bearing at front of pinion shaft. good lock
Follow Ups:
Home
| Forums
Today's Featured Article -
Magic Moments - by Tyler J. Woods. Magic moments don’t just happen. You have to help them along. This morning, I got up early. It is my day off from my regular workweek and I had a lot of things to do. It’s fall, and with winter coming on, there is a lot of work to do before weather closes in.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|