|
Farmall & IHC Tractors Discussion Board |
Re: Super A Drawbar Plate
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim Becker on January 11, 2001 at 18:14:17 from (209.30.247.136):
In Reply to: Super A Drawbar Plate posted by Tyler (MD) on January 09, 2001 at 15:59:23:
OK, I scanned a hitch plate. It is at http://home.flash.net/~jebecker/hitchplate.jpg. Not sure how it ended up so huge but I'm not doing it over. You might want to FTP or save on your system so you can load it, adjust the size and print it. Dimensions (nominal, inches):
wide end 6
narrow end 2.5
length 9
straight section of each side 2.25
thickness 5/8 Hole dimensions for centers of holes:
holes on wide end 3.75 apart
hole at narrow end 6 3/4 from center line of the other 2
all 3 are 1 1/8 in from the close end
center hole 4" from hole at narrow end
center hole 11/16 diameter
3 other holes 13/16 diameter That should be everything you need to duplicate it. Let me know if it isn't.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
