Posted by D Slater on January 21, 2015 at 05:55:46 from (184.14.164.167):
In Reply to: 460 clutch questions posted by diesel833 on January 19, 2015 at 20:08:45:
Early in 350 production when IH added a grease fitting to the sleeve the bearings were changed.
Sleeve 360501R1 used bearings 360502R91 and 363291R91. When the sleeve was advanced to R2 bearing numbers were changed to 365865R91, 365866R91 and 59879D. 460 should have the R2 sleeve with a short pipe with grease fitting.
Don't know what bearings are like now but a dealer shows 59879D at 56.38 and a new number to replace 365865R91 close to 40 bucks. My napa store shows one bearing they use to replace all at around 60 bucks. Found replacements on line for mid twenties. If tractor is used often you may want to compare quality over price if it could mean another split to replace.
This site lists one around 22 bucks. Has a different IH number it replaces though.
This post was edited by D Slater at 06:00:46 01/21/15.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
