Farmall & IHC Tractors Discussion Board |
Re: Farmall H - gears, electrical, carburetor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mark on January 10, 2001 at 07:04:15 from (207.43.106.77):
In Reply to: Farmall H - gears, electrical, carburetor posted by Neal on January 08, 2001 at 20:31:41:
I have found the best way to start is..don't pull choke then hit starter button..hit starter button ....then{pull choke} slowly...next the 6 volt is obsolete ...way too slow for cold starting .....unbolt everything and throw it all away or better yet find some guy who still is a "purest " and hang that 6 volt junk on him..... then if you want to put light's on tractor , you can buy 12 volt light's every where ..where do you find 6 volt whit out PAYING twice as much..As the noise in a" H" ...you will get noise if you have no fluid..drain it and put in new..then maybe you will only have a 5th gear whine noise ..
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|