Posted by puddingstone99 on November 13, 2014 at 15:44:58 from (98.217.197.229):
Hi, I have a problem with the throttle on my new Super C. I am not sure if it is with the governor or with the control lever/arm linkage. The idle is high when the control lever is at its lowest setting. I can gently push the arm with my finger at the governor and the idle drops dramatically. I can do the same thing at the carburetor and push the governor connecting rod to the idle stop with light finger pressure. I have not noticed any surging, and all of the stops seem to be properly set � I just can�t get to a low idle using the control lever. The other thing I noticed is that I can�t get the control lever to reach the maximum setting, it only reaches about 3/4s of the way until I feel a lot of pressure on the lever. Otherwise the lever seems to be working ok.
Is the problem in the travel linkage coming from the control lever, or something (the governor?) not taking up the slack when the throttle is in the lowest setting. Any advice in troubleshooting this is appreciated!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
