Posted by kopeck on November 11, 2014 at 06:09:50 from (66.243.203.185):
In Reply to: Setting Relief valve posted by mkirsch on November 11, 2014 at 04:46:43:
Quoting Removed, click Modern View to see
Yes, this is what I'm dealing with.
It's a SM with a engine driven pump that's using the belly pump as a reservoir, it does not have the stage II type reservoir with built in relief. I feel lucky that the first time I tried it I had it at it's lowest idle so when it stalled the engine I felt lucky.
I was thinking last night and I might have a gauge kicking around, I bought one for my splitter and I don't recall ever installing in. All I would need is a 1/2 to 1/4 bushing.
I'm planning on setting it to 1000 psi (the lowest it will go) and go with that. It's primarily going to be lifting my Saginaw 3-point hitch.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
