Posted by Joshua Rod on October 12, 2014 at 05:13:15 from (208.54.36.181):
Got the Super C running yesterday after a complete overhaul. So happy to here her run again, first time since July 3. Last week i was trying to get it started and there was no gas reaching the cylinders. So after cleaning the carb a few times i got a carb overhaul kit, hardware/float set. Zenith carb. It runs smooth at all rpms, but over half throttle it will die after about ten seconds. Again it runs smooth until it hiccups and instantly dies. I am thinking that the timing is correct and that the gas is cutting out. The IT manual doesnt show anything on carbs, was really dissappointed in it. Is the small screw coming out the front at an angle the idle air speed screw, and the screw coming out the bottom front the rich/lean adjustment? This is an elementary question, i just cant get it to run right. Is there anything else that could be causing this? I have about an hour or so logged on it already driving on the driveway at low and midrange rpms.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
