Posted by bassmasta76 on August 30, 2014 at 09:04:26 from (198.232.63.61):
Good morning everyone,
I've got a few questions:
The first should be rather simple.. I want to remove the exhaust manifold from my H to clean and paint it. Do I absolutely have to replace the gasket or can I reuse it? If I have to buy a new one, I guess it's not the end of the world... just more money I dont really want to spend.... :D
The second question is regarding the Governor. I've noticed oil leaking onto the Engine support block right below the governor. I'm not sure if the gasket that mates the Governor to the front crankcase cover is leaking or perhaps something else.
I'd like to remove the governor to replace the gaskets and check it out and give it a good cleaning, but I've been reading online and there seems to be much conflicting information about whether or not it needs to be timed. The service manual doesn't say anything about timing (at least that I've read), just that it can be removed and how to do that. I'm interested in the expert's opinions on this. I really dont want to screw it up...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Memories of a Farmall C - by Monty Bradley. When I was a child, my grandparents lived on a farm owned by a Mr. Walters. The crops raised were cotton and soybeans, with about forty head of mixed breed cattle. Mr. Walters owned two tractors then. A Farmall 300 on gasoline and a Farmall C, that had once belonged to his father-in-law, and had been converted from gasoline to LP Gas. Many times, as a small boy, I would cross the fence behind the house my grandparents lived in and walk down the turn row to where granddaddy would be cultivati
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
