|
Farmall & IHC Tractors Discussion Board |
Re: painting a farmall h
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George Willer on December 31, 2000 at 18:49:28 from (205.133.30.17):
In Reply to: painting a farmall h posted by b. cloud on December 31, 2000 at 13:21:18:
This one was done with a DeVilbis JGA-502 that I have had for about 30 years. It is a nice gun, but I don't think they are made any more. The paint is IH 2150 without hardener. I have painted 3 Cubs since using an inexpensive HVLP gun from Harbor Freight. Its only advantages are a little less overspray, and easier to clean... but the finish isn't quite as nice. Practice on some implements first to get the feel of the gun and you will do just fine.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
