Re: Blowing head gaskets.

Posted by SDE on August 02, 2014 at 05:33:30 from (184.157.218.181):

In Reply to: Blowing head gaskets. posted by Mr. Farmall A on August 01, 2014 at 10:34:47:

Clean the top of the block and the mating surface of the head. Set the head on the block, without a gasket. Try to push down on each corner of the head to see if you can get it to rock. Get a feeler gauge and try to slide a thin blade between the block and the head. I do not know how much gap will be acceptable, but it is a starting point to determine if one or both are warped.
SDE

Replies:

• Re: Blowing head gaskets. Mr. Farmall A 11:34:52 08/02/14 (2)
  • Re: Blowing head gaskets. rustred 10:45:32 08/04/14 (1)
    • Re: Blowing head gaskets. Mr. Farmall A 12:06:15 08/04/14 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Optional Video Title: Optional Video URL: Advanced Posting Options Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.   Advanced Posting Tools   Upload Photo  Select Gallery Photo  Attach Serial # List  Return to Post

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]