Posted by Larry B. 1486 on July 25, 2014 at 12:41:17 from (72.105.171.170):
In Reply to: b450 farmall project posted by deltafarmer on July 24, 2014 at 20:03:59:
I had a British 450 back in the 1970's and early 1980's and then parts were very hard to come by. very few of the internal parts will interchange with the American FARMALL 450. The engine is completely different. Some sheet metal from a super M will fit. Transmission similar to the FARMALL but none will fit. The B450 has a factory 3pt hitch and a differential lock with a glow plug direct start diesel engine. BD 264 if I remember correct. At the same time I owned a SUPER MD and there was no compairison between the two. The B450 would walk away from the SMD rated having the same hp. There was one parted out at a salvage yard not long ago in Mayfield KY. Still might have some parts??? Steve Smith's 270-247-2219. I still have the owners and parts manual for the one I owned.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
