|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Cub Head Gasket
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill {Antique Acres} on December 28, 2000 at 11:29:24 from (63.162.254.107):
In Reply to: Re: Re: Re: Re: Cub Head Gasket posted by George Willer on December 28, 2000 at 06:20:57:
Well I guess I haven't. If you make sure your threads are good and you have good head bolts then you shouldn't have to worry about it. As I said I went by what the IH parts man looked up in THEIR book and it said 70lbs. That's where it's at and I don't have any problems. It is bored out, head shaved, and bigger carb. It has a lot more compression and runs like a champ. I am curious to know where the 45 lbs. came from or if my IH man is full of it or not. Bill {Antique Acres}
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
