Posted by koehleraj67 on April 01, 2014 at 09:28:06 from (63.231.243.76):
Hello,
its that time of year again to pull out the tractors and get"em going. My F30 Clutch Pressure plate is currently shimmed with 3 washers in all 6 bolts spots in order to keep the fingers from being completely pushed in. This is the only way that I can get the clutch to work. With out the shims the fingers are pushed all the way in and there is no movement or play with the clutch plate which means I have no clutch.
I know that this is not the correct procedure but now am wanting to do it properly. How do I adjust the pressure plate so I can ensure finger movement? Is there any special tools needed? I am pretty good at fixing things but have never had to adjust the clutch yet.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
