Posted by SweetFeet on February 08, 2014 at 03:39:19 from (70.35.103.74):
In Reply to: Re: Farmall A tool set posted by Tom Fleming on February 07, 2014 at 03:25:48:
Tom F.,
Your email is not open on this thread. If you open your email, I will send you an email.
If you have a PayPal account - maybe we can work something out... and it could be my husband's father's day gift.
One thing... they have to be fully rusty looking (to match our rusty old tractor). Is it possible for you to email a photo of them? (This chisel photo is an example of what my husband wants all the tools to look like.)
Or if this is too much complication - just say so, it's ok.
We do have both an orginal tractor manual and a reproduction parts manual - and while the drawings are pretty decent... a few leave something to be desired. For example, on the gas pliers - it does not clearly show me if one handle-end is beveled off. On ebay, some have one beveled handle and some do not.
We bought one sparkplug socket on ebay for $4 - but husband said it does not fit right... so it will get added to a little "rust bucket" in my rust garden by our shop.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
