Posted by SweetFeet on February 06, 2014 at 05:05:33 from (70.35.103.74):
In Reply to: Re: Farmall A tool set posted by Tom Fleming on February 05, 2014 at 04:37:00:
Tom Fleming,
Quote: "The other difficult thing, is that some of the tools were NOT marked IH. Such as the screw driver and spark plug socket."
Do you know if this stands true for the old tools for a Farmall Regular? Especially wondering about:
1.Alemite grease guns... no IHC stamp? 2.Gas pliers?... have seen many on ebay - but never one with an IHC stamp. 3. Is it safe to assume that the older sparkplug sockets were not marked IHC either? 4. Punch? Just wondering about this one because we have found the chisels are stamped on the flat part... being a punch has no wide/flat area though.
Thanks if you can help clarify. We are collecting the set of tools that would have been shipped with our Farmall Regular when it was new.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
