I have 2 fast hitch tractors. A Farmall 450 and A Farmall 806. I also have 2 sets of fast hitch to 3 pt. adapters. Both sets have the offset in them for Cat. 2 equipment, one set has an upward offset in them also, I have found them handy on my 450, the upward offset helps it lift a posthole digger, etc. higher. Both of the styles of prongs I have can be purchased on E-bay. The set I own with the upward bend was purchased on ebay. The other set was purchased from Anderson Tractor parts in Bluffton, Oh, but I think any A+I tractor parts dealer can get them.
As far as hitching goes, I back up close to the implement, in such a position that I can set just the tip of the prong in the socket on the tractor side, and put the ball side on the implement. Then I back up to latch the prongs in place. Very similar to using the telescoping feature if your tractor had come with a factory 3-pt. Here's a couple of links to what I have. The straight set have pulled a 4 bottom over many acres, so I'd say they are pretty well made. -Andy
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
