|
Farmall & IHC Tractors Discussion Board |
Re: Belt Pulley for Super A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on December 14, 2000 at 04:56:17 from (63.15.137.33):
In Reply to: Belt Pulley for Super A posted by Tyler (MD) on December 14, 2000 at 03:22:37:
THE SPLINES ARE THE SAME DIFF DIA FOR RUNNING DIFF STUFF LIKE DIFFERENT HAMMERMILS CORN SHELLERS ECT PULLEYS ARE RATED IN SFPM SURFACE FEET PER MINUTE YOU CITY SLICKERS WILL GET LOST ON THAT THE IMP BEING DRIVEN HAD DIFF SPEEDS ON THE DRIVEN INPUT THENCE DEPENDING ON THE HP REQ TO DO THE JOB AT ENGINE RPM THUS DIFF PULLEYS ONE DAY WHEN WE WERE THRESHING WITH A F 20 A NIEGHBOR BROUGHT HIS NEW M THE PULLEY WAS TO SMALL ON THE M THEREFORE THRES MACH DIDNT RUN FAST ENOUGH WE WERE DOING 100 PLUS BUSHEL OATS DIDNT WORK AT ALL HOPE THIS ANSWERS FOR YOU YOUR FRIEND IN IOWA
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
