|
Farmall & IHC Tractors Discussion Board |
Re: ??Where did the holes stay?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Roger on December 13, 2000 at 09:55:36 from (206.10.52.153):
In Reply to: ??Where did the holes stay? posted by Alvin on December 12, 2000 at 18:09:16:
I havenot put a late engine in a 560d for about 20 years now but I do remember the late D282 had a oil pressure relief cartridge in block where all the original 560 282engines had the valve in the filter base so you have to have the flow thru the base correct
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Ford 600 Series - by Staff. The Ford 600 Series tractors bean production in 1954, and continued until 1957. Quite similar to the Ford NAA (Golden Jubilee) in design, it used the same 132 cubic inch Red Tiger engine with 31 horsepower. Several different models were made in the 600 Series, and these numbers were used to denote whether they used a particular transmission, hydraulic system, or PTO. The result was five different model numbers: 620, 630, 640, 650 and 660. These break down as follows:
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
