Posted by david smithh on December 10, 2013 at 18:48:41 from (50.140.164.140):
Well I am going to start working on my 26 round ball governor regular next week. Found a nice original 30 model that is very nice and clean and the motor is super clean to use for a parts tractor. I hate to part out a nice original tractor for parts but I"ve been told my 26" is fairly rare? I"ve posted pics on here long time ago but decant find them. My engine is completely junk in the 26 so I"m going to take everything out of the 30 block and install into the 26 crank cam sleeves pistons bearings everything I was wondering if I will run into any snags for the internal swap? Also my 26 block number is 2425 but the toolbox tag is gone can I get a new tag for it and if so would it be the same as the block number? There is not a number in the frame of my tractor. Thank you for the help as this project is going to take a while as this tractor is scrap steel beginnings
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.