|
Farmall & IHC Tractors Discussion Board |
Re: rough engine at no load/idle
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Denny on December 06, 2000 at 08:10:58 from (12.4.181.2):
In Reply to: rough engine at no load/idle posted by Harold Seymour on December 05, 2000 at 13:33:39:
Check your valve tappet clearance too. My Super H would drop a cylinder when warm at idle. One intake valve had WAY to much clearance. Also You didn't say what year your H is but safe to figure it's 50+ yr. old. Probably time for new valve springs. They get old & weak and don't seal the valves well. Dad had a '42 H that would idle on about 2 cyl. and new valve springs really smoothed it out.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Dad's Old Silver King and Joe Capalco - by Woody E. Diehl. My father, Charles Diehl, grew up in the Elsworth, Ohio area during the Depression on a small working farm. I never saw the place, nor was I around during his early years. What I know about those hard times comes from listening to Dad and his old pals reminisce from time to time. One of the old timers that would sit with Dad and chew the fat about the 'good ole days' was Joe Capalco. Joe wasn't like most of my Dad's friends. He rarely worked that we knew of. Always had plenty of time
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
