|
Farmall & IHC Tractors Discussion Board |
Re: Paint Removal...How's Best?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by sammy the RED on December 05, 2000 at 10:01:10 from (209.130.145.25):
In Reply to: Paint Removal...How's Best? posted by AGEN on December 05, 2000 at 09:05:10:
1] Scrape off old junk build up.
2] Spray with lemon scented, no fume oven cleaner.
3] Power wash.
4] Wire brush. Power or hand.
5] Use paint stripper, putty knife and screw driver where needed.
6] Sand with 80 or 100 grit.
7] Sand with 150 or 200 grit.
8] Sand with 280 or 325 grit.
9] Repair nicks and dents.
10] Bottom coat.
11] Top coat.
12] Good luck.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The River Tractor - by Charlie English Jr.. This is a 4010 John Deere that was used to farm on the Diamond Island which is in the Ohio River about 15 miles southwest of Evansville, Indiana. About ten years ago, this tractor was parked close to the bank as the river was washing the bank of the island away.
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
