|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Voltage to magneto
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dick B. on December 04, 2000 at 15:02:03 from (64.12.102.159):
In Reply to: Re: Re: Voltage to magneto posted by Dave on December 04, 2000 at 10:40:16:
Did Wico make replacement distributors? What he says sounds like no Wico I've ever seen before. It has always been my understanding 12 volts to the points will cause the points to burn because of low rpm operation (read: lack of dwell time to disipate heat created by the stronger voltage arcing). Am I correct about this? That actually happened to me when I was a kid. I had a '57 Chevy with the ballast resistor wired incorrectly, full 12 volts to the points at all times. I would run until you idled it down for any appreciable length of time, then the points would burn. Before I figured out what was wrong I got pretty good at changing one piece GM points! Luckily the dwell was usually preset right on the money right out of the box. Adios,
Dick B.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
