Posted by Owen Aaland on September 06, 2013 at 10:45:53 from (216.47.32.23):
In Reply to: 11/16 bolt posted by Frank Caldwell on September 06, 2013 at 04:32:26:
Frank Caldwell said: (quoted from post at 07:32:26 09/06/13) I am wanting to put a weight bracket on the front of my W9. The thread insert seems to be 11/16. (5/8 is to small & 3/4 is to big). The local IH dealer & Fastenal does not have this size. Any suggestions.
What do you mean by "thread insert"?
If the hole has been damaged and repaired with a Heli-Coil insert which than has been removed you will end up with an odd size hole. Heli-Coil uses there own special taps for their inserts.
Where is this hole located on the W9?
I just went out and checked the holes on my W9. All the holes in the front are 3/4" NC thread.
This post was edited by Owen Aaland at 10:56:33 09/06/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
