Posted by Gordon Sorensen on August 26, 2013 at 09:33:15 from (15.219.153.76):
I have a IH 354 utility tractor with the gas engine, BC144. I need to pull the sleeves and at a minimum replace the "O" ring seal. Finding an "O" ring for the sleeve is turning into an adventure. I would consider buying the sleeve kit, sleeve, piston, rings, wrist pin, retainer, and hopefully the "O" rings if I could find a kit for the BC144 engine. There are kits available for the BD144 engine. Interestingly my I&T shop service manual list the bore and stroke for the the BC114 and the BD144 as being the same. The rod and main bearings as is the piston pin sizes are also listed as being the same sizes for the the BC144 and BD144. My question is would a sleeve kit for the BD144 also work in the BC144 block? I am thinking the piston is going to be different (5 rings for the diesel, 3 rings for the gas) but should work. Any suggestions would be welcomed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
