|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Does anyone have info about Super H demonstator
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Denny on November 29, 2000 at 14:27:53 from (12.4.181.2):
In Reply to: Re: Re: Re: Re: Re: Does anyone have info about Super H demonstator posted by RB Oh yea! on November 28, 2000 at 17:14:44:
I've researched this for over 25 yr. getting ready to get MY Super H ready for the second 50 yrs. 300 was 3-9/16 same as Over-size Super H and the 350 was 3-5/8 with no O/S avail. I even wrote a real nice letter to M&W GEAR 20 yr. ago about if 3-5/8" 350 sleeves would fit in a Super H. They're responce was "Not without Boring the Block". I figured 3-9/16" was big enough then but those 6 cubic inches would have been nice.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
