This is NOT 2 independent planter units on a tool bar. It is 2 planter hoppers driven by the press wheel, through an exposed transmission.
Both the left and right planter units can be adjusted for row width through a series of holes in the mounting bars.
My guess is you adjust the depth of planting by the turn-wheel seen from the rear, that threads into 520469R1, the female part of this assembly.
There are 2 plates in the planters now, don't know the part number on them. I also have (3) plates 62717R3 that look like the same plate design (I don't know what seeds they are designed for), These plates are very flat.
I also have these planter plates, but I don't know if they fit this planter : (3) CPB Peanuts In Hull (1) R7036 Spanish Shelled Peanuts (1) CPC5133 Small Corn (1) CPC5044 Small Corn These plates are very cupped, maybe 1 1/2 inch ?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
