|
Farmall & IHC Tractors Discussion Board |
Manifold and Transmission Questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeff Again on November 02, 2000 at 11:08:14 from (208.155.194.91):
I have two questions (1940 Farmall H): 1. When I'm in 2nd gear the tractor runs fine. When I push in the clutch (in 2nd gear) the gears make a sound like when you accidently try to put the tractor in gear while the transmission is rotating (grrrrr). I can stop this from happening if I take it out of 2nd and put it into neutral, or I can prevent it if I pop it out of gear without using the clutch. My question is: why would it work fine until I push in the clutch? This doesn't happen for any other gears, and when I looked at the transmission through the belt pulley opening it looked fine and the gears meshed fully. 2. I replaced the manifold/engine gaskets on both of my H's (distillate manifold). I tightened the manifold securely. After the engine ran awhile an annoying high pitched squeal started. I pushed and pulled on the exhaust pipe and the pitch changed or went away temporarily, but it stuck around most of the time. What in the world happened? I'm also wondering why this would happen since the manifold and engine are separated by the gaskets. I've noticed that my questions get stranger as time goes on...............
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|