|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Super A loses oil pressure
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Denny on November 02, 2000 at 09:09:07 from (12.4.181.2):
In Reply to: Re: Re: Re: Super A loses oil pressure posted by Bob M on November 01, 2000 at 11:00:47:
Bob - That's really good Oil psi for a Super M. There were changes in the engines in the Super Series to reduce the Oil PSI. I grew up about 20-25 miles from where these tractors were built. It was common for local dealers to run the new tractors from the plant to their shops as opposed to haul them. The first SM's & SH's my Dad tells me didn't even make it out of Rock Island & Moline, IL. before the drivers returned to the plant due to the low Oil PSI. I have seen more Super H's with holes in the side of the engine blocks due to spun rod bearings than H's. My Super H only has to plow snow for another couple of years until it gets rebuilt. Pistons, Rings, Sleeves, head totally rebuilt, and all the seals & gaskets. It's always been serviced well, been kept tuned, and never really set for long periods where it was in damger of sticking. And has ALWAYS been under roof.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
