Posted by Picklesmith on December 04, 2012 at 12:35:20 from (24.116.104.133):
I have a 1948 Farmall M with the LiftAll accessory. I need assistance concerning how to configure or connect the hydraulic hose(s) from the liftall to a single hydraulic cylindar on a towed John Deere #55 plow. The problem I am having is that using only one hose from the liftall to the cylindar allows me to lift the plow but, I have to rely on gravity to drop the plow. In this configuration, I cannot quite get the plow to "dig in" when plowing. When I connect two hoses to the lift all (using A&B ports on the liftall), I cannot lift or lower the plow very well. The cylindar on the plow is a 3x8 off-the-shelf type item and not the cylindar that JD apparently had as original equipment on the plow. Any assistance would be appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
