Posted by Dan MD on November 25, 2012 at 06:31:18 from (184.158.3.213):
So I have a SMD that has less than 50 hours on it since a complete rebuild. I have been sorting out some injection pump issues and was running a test the other day. I had the fuel injection lines plumbed into bottles and was running it on gas, looking for fuel delivery variations. After running about 5 minutes on gas, I heard a very loud bang from what sounded like the engine opposite from where I was standing by the inj. pump. This BANG never effected the engine as I ran it another 2 minutes finishing my test. I"m not even sure it wasn"t something falling over in the garage, but I didn"t find any culprits.
What should I be checking? I did a compression test after this happened and everything looked good there. The starter rolls the motor over evenly. Should I be dropping the pan and valve covers or is it unlikely the BANG was the tractor since it still ran fine afterwards?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
