|
Farmall & IHC Tractors Discussion Board |
C cultivator clamps and 3 point adaptor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by FC on October 24, 2000 at 07:14:21 from (63.80.243.2):
Does anyone know if the cultivator clamps on a C have an offset up or down based on turning them over one direction or the other? I purchased a 3 point adaptor like the one in the link below and it is interfering with my factory drawbar and manufacturer says it should not and my cultivator clamps it mounts to may need turned over to allow it to clear. My tractor is a distance away and I can't recall any offset up or down. All I know is they have been on tractor many years like this. Anyone have experience with one of these hitches? I will not be too happy if I must lose the factory drawbar to use this. Thanks, FC
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
