Posted by Janicholson on October 31, 2012 at 18:33:48 from (96.24.99.126):
In Reply to: six volt starter posted by red theo on October 31, 2012 at 17:12:52:
Assuming the removal and reinstall worked, a new style starter drive is available Here on this site, and other places that assist in making them work correctly. If the ring gear has even 50% of the worst teeth remaining it can be a near permanent solution. If the starter still fails to turn the engine, feel the cables and connections any heat detected is a place to fix. The cables are often replaced with 4 gauge auto cables. they will result in slow spinning and loss of power to the starter. Using 00gauge cabled (truck repair, welding cables, or NAPA, with soldered on terminals work wonders for an M. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
