|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Farmall A fan assembly
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill {Antique Acres} on October 09, 2000 at 07:19:37 from (63.162.254.63):
In Reply to: Re: Re: Farmall A fan assembly posted by AGEN on October 08, 2000 at 21:53:08:
I recommend putting the bearings in. I did this on my Cub, same assembly just smaller. I also put a grease zerk in the assembly and pumped it full. It will stay in fairly well and don't sling everywhere. Then every now and then just hit with a couple pumps. The reason I did this is because all the oil came out and I didn't know it and it locked up and killed the engine. I thought the motor locked up. Turned out to be just the fan. My 2 cents. Bill {Antique ACres}
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
