|
Farmall & IHC Tractors Discussion Board |
Re: 450D Shutdown
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by H MN on October 08, 2000 at 01:56:50 from (209.254.130.14):
In Reply to: 450D Shutdown posted by George on October 07, 2000 at 20:04:35:
George: With out a doubt the MANUAL is right. Go back to gas for a short spell and then the kill switch and when stopped return the "run on gas" lever to off. So ya end up with switch off, gas off and diesel off. Its very important to also let the engine run a while to cool down after hot\heavy work to prevent cracking the head. Cracked heads was a bit of a problem with people who did NOT follow the manual. Hope yours is still OK.. Its a great engine. I grew up sitting behind a MD and SMD 4 cylinder diesels. Enjoy using it. harvey
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Restoration Story: 1929 McCormick-Deering 10-20 - by Randal Simmon. On July 4th 1998 my dad and I was sitting on the front porch when he said that he was going to sell his two 10-20's to a junk man. He said that the junk man was going to give him $500 for both of them but he hadn't received the money for them yet. So I went into the house and wrote him a check for $500 and bought them myself and said now they are mine. He had bought them about five years before thinking that he was going to restore them himself. After five years sitting in the barn, he changed h
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
