Ok so i messed up Everywhere i typed regulator i meant Generator....
ALSO i did not put in the the warning light in there as the wiring guide showed. I just didn't hook that wire on the alternator to anything and caped it off with a wire nut and electrical tape. I'm assuming it will still work without he light, If I'm incorrect let me know.
Edit: Thank you for the reply. the belt he had on there was to wide for the pully on the Delco 10SI but i know we have a few belts laying around off old Toyota's that i can cut to do this that are the right width.
This post was edited by Dragonclaw at 16:38:58 08/08/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 50 Tips for Ford N Owners - by Bruce Haynes. Over the years of owning these three tractors, I have managed to refresh what little mechanical knowledge I had and add a little more, thanks to the wisdom and helpfulness of many fellow N owners. So, now it's my turn to share a few of the tips I've picked up.
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
