Posted by TMonton on July 29, 2012 at 08:54:16 from (75.46.90.81):
This topic has been kicked around a couple times and thought I would re-open floor on this one.
I will admit it is a very good match for color but ...
I am using a rattle can to do those odd little pieces and am not very impressed with the finish quality. It's been 4 weeks of drying and I am still able to peal and/or push a thumb nail into the paint surface.
My best assumption is that it will not dry with a hard surface. Looking around I can find thumb prints and gouge marks all over now. Trust it didn't take long to muddy up the surface reassembling things either.
My best advice is ... avoid this method if you wanting a good quality gloss finish.
I'm just glad I didn't go very far before finding this little quirk out. What I have done can be easily redone but face it ... once was bad enough and why create extra work.
Painfully I will be moving away from this specific product searching for Valspar once again. The local TSC wasn't carrying it anymore and is why I ended up here ... a disappointment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
