Posted by CNKS on July 16, 2012 at 17:47:34 from (216.144.104.128):
In Reply to: Converting A to AV posted by Mark Capps on July 16, 2012 at 08:13:42:
The height of the SA front axle and the rear axle housing of the C are within 1/2 inch of each other -- 23" +/-. The lower drop axle housing on the A/B, depending on row width/tread setting gives the edge to the C. I grew up on a vegetable farm in south Texas, cultivating tractors were H's and B's. I don't remember a clearance problem. The axle clearance is a non factor anyway. The vegetable cultivators we had, had the feet/sweeps attached to bars that were at least as long as the wheels were wide. Much taller than the cultivator bars, if we cultivated we also cut the roots of the crop.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
