|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Rob Johnson -W6
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by robert on October 01, 2000 at 17:04:27 from (202.72.131.105):
In Reply to: Re: Re: Rob Johnson -W6 posted by Rob Johnson on October 01, 2000 at 01:36:01:
As far as I can remember the splines etc were good and tight,Freight would be a killer from over here.I will take the loader up and check them.Having same problem as you in finding rubber 13.50x 28 hard to get may go with 16.9 x28 as these are more readily available S/H eg chamb combine & massey 80.
The AW6 came with a W6 I bought the W6 was complete & running.Somebody had used it for bits.
I am based at Quairading 100miles east of Perth
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
