Posted by soybeanjoe on June 30, 2012 at 19:38:52 from (66.213.171.108):
In Reply to: plow for 1206 posted by schrocky on June 30, 2012 at 05:49:09:
The guys who had 1206s around here back when they were new normally pulled a 16" # 560 plow. In our soils that was all a stout 12 wanted. Normal plowing gear would have been L-3 & in a lot places L-3 with the TA pulled back.
I had a '67 806 D that I pulled a 14" 560. Basicialy the same gears as the guys with the 12s & 6x16s. Many spots I felt like getting off & help push the tractor thru the tough spots. Probably at least 50% of the guys with 8s pulled 16" 550s which was a little bit better matchup.
N way in our Sable & Ipava loams would a 1206 pull a 8x16" plow. We have a 7x16" 720 on-land plow that we pulled behind our MX 275 mfd last yr and in places you knew it was back there
As others have stated, I don't recall IH ever making a 8x16" in-furrow plow. I think maybe Massey did but not positive of that, may have been on-land as well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
