|
Farmall & IHC Tractors Discussion Board |
Re: Super H Liftall and Remote control.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dennis Frisk on September 27, 2000 at 12:47:10 from (12.4.181.2):
In Reply to: Super H Liftall and Remote control. posted by Dennis Engelking on September 27, 2000 at 12:28:22:
I have Super H # 22357J. Your tractor has the transmission driven Hyd. pump. Those capped elbows are for lifting each side and/or the rear section of a mounted cultivator. The Remote control WAS an option. You can't run 2-way cylinders with what you have now, only 1-way. Even my SH w/ Live Hyd didn't have it. I had to put an after-market conversion valve on. You can run remote cyl. with what you have if you put a Hyd. connector on it. ROCKFORD was the manufacturer of the engine clutch disc and pressure plate. IHC used them exclusively. They became part of Borg-Warner and were located in Rockford, IL. Your tractor was one of 19,227 made. I would estimate Your tractor to have been built about August of 1953.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
