Posted by Jim Becker on May 20, 2012 at 20:14:03 from (173.74.120.222):
In Reply to: Magnet Update posted by JRSutton on May 20, 2012 at 05:32:03:
This is the reporrt I was expecting. With the traps you have been through, I was confident that your magneto and timing problems were behind you.
As a certified member of the Correct Police, I need to comment on that subject too. Gene makes a good point. If the magneto had been an H-4, the one designed for the letter series tractors, it would have gone right on and this problem would have never come up. Of course, if the person who originally installed the Wico had known what he was doing and properly set the lag angle on the Wico, the problem wouldn't have come up either. Such are the things we get into following previous owners and their made-do repair work.
On the plus side, this is a 4-H project. I'm sure that JR, along with anyone else that may have worked on this part of the project, learned a lot more about magnetos and timing than they would have if the right parts had been there.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
