Posted by doehmke on May 08, 2012 at 02:36:32 from (206.205.236.2):
In Reply to: F20 Engine posted by Dan Oehmke on May 04, 2012 at 19:56:02:
This manual has a lot better pictures than my shop manual or parts book. Not entirely sure about felt seals, but it appears there is only one felt in the font between the front cover and the fan pulley. And one larger felt on the back end of the crank.
I have two other types of felt series from Rice, one which I think is for wheels? And not sure on the other. Their parts numbers were not in the reference list in the back of my posts manual.
Anyhow, got the front end together except for the engine mount and fan pulley and got the head and water manifold on. I put the original 4 inch pistons into bored out used sleeves, new bushings and tenanted connecting rods.
Next time I get up North to where the tractor is at, I plan to do the bell housing end and lift the engine into the frame.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
