Posted by Ron-MO on April 12, 2012 at 12:17:16 from (24.177.135.98):
In Reply to: Super C Hyd pump seal posted by teddy52food on April 12, 2012 at 10:00:43:
Dean is correct, I ran into the same issue, and there is more than one pump on those. I finally found a dealer that walked up to a drawer and pulled out the correct o-ring. Nothing at the automotive parts stores were even close to matching the one in my old pump. I am hoping that since the first one lasted nearly 60 years I won't have to go back into mine again. Local dealer made it obvious he did not want to put any effort forth to try to find one, and quickly turned to trying to sell me a pump for over $600. But it took me probably 6 hours or more driving from dealer to dealer to finally find a parts guy who knew what he was doing. The guy that found it was looking at microfich before finally arriving at the correct ring.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
