Farmall & IHC Tractors Discussion Board |
Help...How to Attach Single Bottom Plow to Super AV
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Phil on September 18, 2000 at 17:22:58 from (152.163.197.67):
I have a 1952 Super AV (High Clearance)tractor with an original Draw bar with the original drops for the draw bar for the AV. Everything seems correct for the high clearance drawbar as shown in my owners manual. My problem is how do you hook the plow up (IH single bottom 14). I turned the drawbar backwards (180 degrees) so that it is basically under the tractor. The problem is when I bolt the plow to the drawbar, it seems too far under the tractor, it would throw the dirt on the tractor tire. Seems about two feet forward too much. The chain on the plow will not even reach the arm on the tractor. Do I have to do something special for a high clearance tractor? Any help from someone that has used a setup like this, or information from a plow manual would be greatly appreciated. If someone does know how to hook up the plow, once the plow was back in the proper position, how do you adjust it so that it will dig in before you have the first farrow? I am used to using more modern equipment a three point and you adjust the arm of the tractor and the three point to get started plowing and then adjust it again once you get the tires in the farrow.
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|