Farmall & IHC Tractors Discussion Board |
Re: Re: I Never Thought Of This!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill {Antique Acres} on September 16, 2000 at 18:19:47 from (216.192.152.28):
In Reply to: Re: I Never Thought Of This!!! posted by Les Repair on September 16, 2000 at 17:55:17:
I am far from a electrical expert, so please don't hold any of this info against me. But a 6 volt generator will not put out much more than 6 volts unless the brushes are moved. I also am pretty sure that in order to get 12 volts out of a generator the windings inside have to be changed. I am probably way off, but my neighbor has owned a auto electric shop for 25 years and I do know that he has to do something to make a generator 12 volt in addition to adding a 12 volt regulator, beacuse I have watched him do it. Amps plays a big part in charging, but you can have all the amps in the world on a 6 volt system and put on a 12 volt regulator and it won't charge a 12 volt battery. I hope somone else can clear up this muddy water I have made. Thanks Bill {Antique Acres}
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|